The 50 Plus Cafe, Pub, All-Nite Greasy Spoon and Dive Bar

Source: Horologica - Clocks - Intermediate Oiling
Source: NWACC - How to Oil a Clock
Source: Grandfather Clock Repair Service - How to Oil a Clock

Tip: Ctrl+F then search for oil

ETA: They all appear to suggest the same thing: less is more with oil... and be sure to remove as much of the old oil as possible before adding the new.


I think that the point of the removal bit is to remove any filings and/or dust that might have gotten in it. Gun patches might be the ticket for that.
 
Source: Horologica - Clocks - Intermediate Oiling
Source: NWACC - How to Oil a Clock
Source: Grandfather Clock Repair Service - How to Oil a Clock

Tip: Ctrl+F then search for oil

ETA: They all appear to suggest the same thing: less is more with oil... and be sure to remove as much of the old oil as possible before adding the new.
Thanks MissK! Well, the verdict is in. Not going to be an easy job. Can’t use 3in1, nor WD…have to get some fancy Earl from Europe. Probably cost me an arm and a leg just to put a pin drop in? 🤨.

No…

We’re gonna find a work around…
 
Yes, really. Too much can increases friction, and will capture dust.

Actually, I think not. It's a clock, not an anvil engine.
Y’all are right. All the Xperts are say’n if you use too much and get a run, all the oil will follow and then yer high and dry again.

I considered punting and hiring a pro. Then I could look over his shoulder and do it myself in three years. This thing was inherited and I can guarantee it’s never seen a drop of oil. The little devil on the shoulder is saying, “No problem, you can do it yourself!”
 
Back
Top