SeaCat
Hey, my Halo is smoking
- Joined
- Sep 23, 2003
- Posts
- 15,378
This afternoon I decided it was time to hang the outside sensor for the Thermometer. I chose one of the uprights for the patio as the place to hang it. I grabbed the cordless drill and started drilling at roughly head height. When the bit broke through I was greeted with a solid stream of water blasting several feet into the patio. I quickly pulled the drill out of the way and grabbed a bucket that was on the patio and started catching this water. Talk about some evil looking stuff, it was white.
After a short while the upright had drained down enough so I could put down the bucket. I looked at the upright and grabbed the drill once again. I went outside and drilled a hole half an inch above the bottom end of the upright. This time I was ready for it and had the drill out of the way as the water blasted out. Now this upright is a hollow aluminum post six inches wide by two inches thick. There was quite a bit of water in there and all of it was this terrible looking stuff.
After a quick shower I was back out there and finished hanging the sensor.
Cat
After a short while the upright had drained down enough so I could put down the bucket. I looked at the upright and grabbed the drill once again. I went outside and drilled a hole half an inch above the bottom end of the upright. This time I was ready for it and had the drill out of the way as the water blasted out. Now this upright is a hollow aluminum post six inches wide by two inches thick. There was quite a bit of water in there and all of it was this terrible looking stuff.
After a quick shower I was back out there and finished hanging the sensor.
Cat